Fimer PVS-175-TL - Installation; Installation Safety Instructions

FIMER_PVS-175-TL A.1 Version_Product manual_EN_RevC-
F
54
Installation
Installation safety instruction
WARNING – B The inverter panels/covers can be removed from authorized service personnel
only (the users are not authorized to remove inverter panels/covers).
WARNING – B When the photovoltaic panels are exposed to sunlight they provide continuous
DC voltage to the inverter. Before installation may begin, photovoltaic panels must be shaded
or isolated.
WARNING – B It is important to remark the presence of auxiliary power supply connected
to the AC grid. This inverter is supplied either by DC and AC power, so hazardous internal
voltages are present even in case the DC switches are open.
WARNING – B The installation must be carried out with the equipment disconnected from any
voltage sources. Refer to “Inverter total de-energization and safe access” paragraph on
this manual to know all the necessary step to safely operate on the inverter.
ATTENTION – A This device is intended to be installed in a suitable plant for its use and its
purpose. All the installation instruction described in this chapter must be followed considering
the plant structure where the device is intended to be installed. Its performance therefore
depends on the correctness of the installation.
ATTENTION – A It is mandatory to adhere to the indications provided in this manual, the
diagrams and the enclosed documentation, paying attention to follow the installation
sequence exactly as described in this manual.
ATTENTION – A Staff authorised to carry out the installation must be specialised and
experienced in this job. They must also have received suitable training on equipment of this
type. The installation must be performed by qualified installers and/or licensed electricians
in accordance with the existing regulations in the country of installation.
ATTENTION – A Handling and installation operations shall be performed only by using
the special tools and accessories provided with “PVS-175 Installation Kit” that have to be
ordered separately. The use of these equipment are mandatory to safely install the inverter.
Refer to “Kit of recommended spare parts” paragraph for further information.
ATTENTION – A The local electrical utility (or authority having jurisdiction) must approve the
equipment installation before it is connected to the electrical grid.
5