Fischer Panda 18 - Page 142

Maintenance Instructions
Seite/Page 142 - Kaptitel/Chapter 7: Maintenance Instructions 18.12.15
Fig. 7.12.2-31: Remove markingsRemove markings
Fig. 7.12.2-32: Mounting the oil capTighten oil cap:
By doing that, pay attention that the O-ring stays in its flute. If
necessary, fasten the O-ring with a bit of grease (Tool: Allen
wrench SW6).
Nut torque M6: 10 Nm
Fig. 7.12.2-33: Fill up the oilFilling up the oil:
Up to the middle of the inspection glass /-hose.
Oil type:
Shell Omala S4 GX 220
Shell Omala HD 320 (Temperature over 35°C)*
Mobil 1 0W-40 **
Oils that have the following specifications, are classified as
adequate:
synthetic gear oil (PAO)
Grades of oil 220 to 320
Minimum requirement gear oil: CLP HC
These oils are available at industrial lubricant commerces as
well as Fischer Panda.