Fischer Panda 18 - Set up the Contrast of the CP-G; Set up the Standby Time out of the CP-G

Panda xControl
18.12.15 Kapitel/Chapter 11: Panda xControl - Seite/Page 229
Fig. 11.5.3.1-1: Submenu „brightness“Increase /decrease with the „Step-up“/“Step-down“ buttons
the value and confirm with the „Start/Stop - Enter“ button.
Choose cancel or confirm with the „Step-up“/“Step-down“
buttons and confirm with the „Start/Stop - Enter“ button.
11.5.3.2 Set up the contrast of the CP-G
Scroll with the „Step-up“/“Step-down“ buttons to the menu point „contrast“ and confirm with the „Start/Stop - Enter“
button. You enter the menu point contrast.
Fig. 11.5.3.2-1: Submenu „Contrast“Increase /decrease with the „Step-up“/“Step-down“ buttons
the value and confirm with the „Start/Stop - Enter“ button.
Choose cancel or confirm with the „Step-up“/“Step-down“
buttons and confirm with the „Start/Stop - Enter“ button.
11.5.3.3 Set up the standby time out of the CP-G
Scroll with the „Step-up“/“Step-down“ buttons to the menu point „standby time out“ and confirm with the „Start/Stop -
Enter“ button. You enter the menu point standby time out.