Fischer Panda 18 - Failure Code; Failuretable

Panda xControl
Seite/Page 240 - Kaptitel/Chapter 11: Panda xControl 18.12.15
Fig. 11.6.1.2-2: Sensor broken english
Fig. 11.6.1.2-3: Sensor broken german
11.6.1.3 Failure code
Fig. 11.6.1.3-1: Failure codeA Failure code is shown if any parameter run out of the
specified range.
see “Failuretable” on page 240
11.6.2 Failuretable
See chapter „Failure“ of your generator manual for help.
Fig. 11.6-1: Failure codes
No.. Description Cause Explication Warning Gen.Stop Info
1 AC-Voltage Voltage to low yes yes n.a.
2 AC-Frequency Frequency to low yes yes n.a.
5 Emergency Emergency button pushed Contact „emergency“ open n.a. yes n.a.
7 Oil pressure Oil pressure to low Failure oil pressure switch n.a. yes n.a.
13 Starter power Starter failure short circuit
Starter defect
yes n.a. n.a.
14 Glow circuit Glow circuit failure short circuit
defect
yes n.a. n.a.
16 Fuel supply Failure fuel supply short circuit
defect
yes n.a. n.a.
17 Stop solenoid - Hold Failure stop solenoid hold coil short circuit yes n.a. n.a.
18 Stop solenoid - Pull Failure stop solenoid pull coil short circuit yes n.a. n.a.
19 Optional DC out Failure optional DC out short circuit yes n.a. n.a.