Panda xControl
Seite/Page 216 - Kaptitel/Chapter 11: Panda xControl 18.12.15
11.3 Operation
The xControl will be controlled with the xControl CP-G panel.
Fig. 11.3-1: xControl CP-G Front Side
11.3.1 Switching on the generator
Fig. 11.3.1-1: Switch the generator onPress the „ON/OFF“ Button to switch the generator on
With this you switch the generator into the standby mode.
If the automatic start option is set in the menu, the
generator may start by an external signal.
Fig. 11.3.1-2: Welcome screenThe CP-G Panel shows the welcome screen for 2 seconds.
To Next Page
Loading...
