Fischer Panda 18 - Set up the Standby Brightness of the CP-G; Set up the Way of Illustration of the Overview Screens of the CP-G

Panda xControl
Seite/Page 230 - Kaptitel/Chapter 11: Panda xControl 18.12.15
Fig. 11.5.3.3-1: Submenu „standby timeoutl“Increase /decrease with the „Step-up“/“Step-down“ buttons
the value and confirm with the „Start/Stop - Enter“ button.
Choose cancel or confirm with the „Step-up“/“Step-down“
buttons and confirm with the „Start/Stop - Enter“ button.
11.5.3.4 Set up the standby brightness of the CP-G
Scroll with the „Step-up“/“Step-down“ buttons to the menu point „standby brightness“ and confirm with the „Start/Stop
- Enter“ button. You enter the menu point standby brightness.
Fig. 11.5.3.4-1: Submenu „standby brightness“Increase /decrease with the „Step-up“/“Step-down“ buttons
the value and confirm with the „Start/Stop - Enter“ button.
Choose cancel or confirm with the „Step-up“/“Step-down“
buttons and confirm with the „Start/Stop - Enter“ button.
11.5.3.5 Set up the way of illustration of the overview screens of the CP-G
Scroll with the „Step-up“/“Step-down“ buttons to the menu point „way of illustration“ and confirm with the „Start/Stop -
Enter“ button. You enter the menu point way of illustration.