Panda xControl
18.12.15 Kapitel/Chapter 11: Panda xControl - Seite/Page 217
Fig. 11.3.1-3: Address screenAfter that the CP-G shows the address screen for 1 second
Fig. 11.3.1-4: Overview screen 1 symbolicAt the end of the switch on, the CP-G Panel will show the first
overview screen.
Which screen the display shows (symbolic-english text-
german text) can be set up in the menu.
Fig. 11.3.1-5: Overview screen 1 english text
Fig. 11.3.1-6: Overview screen 1 german text
11.3.1.1 Overview screen with activated autostart
Warning! Automatic startDanger for life! - The generator can be equipped with a
automatic start device. This means the generator can be
started by an external signal. To avoid an unexpected starting
of the generator, the starter battery must be disconnected
before start working at the generator.
The „Automatic Start“ will remain activated, even if the
xControl CP-G is switched off and on again.
If any failure occur while the generator is starting or running,
the generator will stop and the „Automatic Start“ will fall back
To Next Page
Loading...
