Fischer Panda 18 - Check the Event Log of the CP-G; Reset All Values of the Generator Submenu to Standard

Panda xControl
18.12.15 Kapitel/Chapter 11: Panda xControl - Seite/Page 237
Fig. 11.5.4.5-1: Submenu „switch outputs“Choose „f.-pump“ or „opt. DC“ with the „Step-up“/“Step-down“
and change the value from 0 to 1 or back with the „Start/Stop
- Enter“ button.
If you set the value to „1“ the output will be switched on, if you
set the value to „0“ the output will switched off.
To return to the generator menu choose „back“ with the
„Step-up“/“Step-down“ buttons and confirm with the „Start/
Stop - Enter“ button.
11.5.4.6 Check the event log of the CP-G
Scroll with the „Step-up“/“Step-down“ buttons to the menu point „event-log“ and confirm with the „Start/Stop - Enter“
button. You enter the menu point event-log.
Fig. 11.5.4.6-1: Submenu „event-log“
Scroll through the event log with the „Step-up“/“Step-down“
buttons and return to the generator menu with the „Start/Stop
- Enter“ button.
11.5.4.7 Reset all values of the generator submenu to standard
Scroll with the „Step-up“/“Step-down“ buttons to the menu point „reset to standard“ and confirm with the „Start/Stop -
Enter“ button.
Eventnumber
QR Code for
internal use
Failure Code
Failure time