FISCHER MMS - Page 100

Glossary
96 MMS
®
Inspection DPM High
Night
Brightness mode for the display (Gage Settings menu). The display brightness is
set for optimum reading of the display values/parameters by night and in unlit
rooms; setting see page 67.
No
Limit monitoring is deactivated; setting see page 24.
Not enabled
Parameter of the alarm function, deactivates the alarm function for selected cli-
matic variable, setting see page 26
Office
Brightness mode for the display (Gage Settings menu). The display brightness is
set for optimum reading of the display values/parameters in offices and under
artificial lighting; setting see page 67.
Sunlight
Brightness mode for the display (Gage Settings menu). The display brightness is
set for optimum reading of the display values/parameters under direct sun-
light; setting see page 67, indicates this brightness mode.
This brightness mode consumes a lot of energy and thus drastically re-
duces the battery operating time
Switch off
Automatic switch-off after a preset time period w it hou t operation (key use or
measurement acquisition); setting in menu Gage Settings > Energy Savings,
page 71; 0 = disabled automatic gage switch-off
Switch off (USB)
Automatic switch-off after a preset time period w i t h o u t data transfer via USB
interface; setting in menu Gage Settings > Energy Savings, page 71; 0 = disabled
automatic gage switch-off
Upper Tol. Limit
All climatic values above the upper specification limit are flagged and the value
is displayed in red; setting see page 24.