FISCHER MMS - Page 99

Glossary
95
MMS
®
Inspection DPM High
13.2.4 Display texts – Selection/setting parameters
Automatic
Brightness mode for the display (Gage Settings menu). The display brightness
adjusts automatically to the current lighting conditions, so that optimum read-
ing of the display values/parameters is always possible; setting see page 67.
Both
Selection parameters, both a lower and an upper specification limit are moni-
tored during the measurement; setting see page 24.
Dim display
The brightness of the display will be automatically dimmed to a preset luminos-
ity value after a preset time period; setting in menu Gage Settings > Energy
Savings, page 71; 0 = display dimming disabled
Dimmed
Brightness value for display dimming (menu Gage Settings > Display Settings >
Set brightness). In conjunction with the device function Energy Savings, you can
set here the brightness value to which the display is to be dimmed after a pre-
set period of time, see page 68. You set the period of time in the gage function
Energy saving (menu Gage Settings), see page 71.
Greater than or equal
Parameter in Alarm function, threshold from when the visual alarm signal is
activated, setting see page 26
Interval [min]
Parameter of function Auto Logging, setting the time interval in minutes
(0 = function deactivated; Enter: 1 … 99), see page 27
Less than or equal
Parameter in Alarm function, threshold from when the visual alarm signal is
activated, setting see page 26
Lower Tol. Limit
All climatic values below the lower specification limit are flaged and the value
is displayed in red; setting see page 24.