Data transfer
48 MMS
®
Inspection DPM High
b Go to the Measurement view: 3 x .
2. Connecting the gage to the PC
► Use the USB cable to connect the gage to the PC via the USB interface.
3. Settings in the CAQ system
a Register the gage in your CAQ program or connect it to your CAQ
program (
CAQ program).
b If necessary, adapt your transfer program. The output formats of the
measuring device can be found at the beginning of this chapter on
page 47.
The connection settings are finished.
What you can do next
Transfer data, see page 48.
8.3.3 Transfer data via USB to a CAQ system
Before you start
The CAQ program is available on PC for example.
All necessary connection settings have been made in the CAQ system and
in the gage, see page 47.
The CAQ system is ready for data import.
The batch for which you want to transfer the climatic values to the CAQ
system is open in the gage.
Navigation gage
: Selects – parameter/value
: Confirms – selection/setting
:Exits – page/menu
What would you like to do?
Transferring climatic values during the measurement to a CAQ system,
see page 48
Transferring all climatic values from the open batch to the CAQ system,
see page 48
To Next Page
Loading...
