FLIR Quasar Gen III CP-6302 Series User Manual

This document does not contain any export-controlled information.
Configuration and Operation
24
Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021
5.3.3.1 Basic
The Basic screen is used to configure the camera’s basic network settings.
Network > Basic Screen
It is possible to connect to the camera with either fixed or dynamic (DHCP) IP address. The camera also
provides PPPoE (Point-to-Point Protocol over Ethernet) support for users who connect to the network via
PPPoE.
The Basic screen is divided into three sections: General, Advanced and IPv6 Configuration.
General
Select one of the following options in the General area for configuring network settings:
· Get IP address automatically
· Use fixed IP address
· User PPPoE
Get IP address automatically
If you select Get IP address automatically, you can use the DNA utility, which can be accessed from the
FLIR website - see Accessing Camera Information from the Web, to obtain the IP address from a DHCP
server on the network. See the Using the DNA Utility to Search and Access the Camera section of the
Quasar Gen III CP-6302 Range Installation Manual.

FLIR Quasar Gen III CP-6302 Series Specifications

General

Brand	FLIR
Model	Quasar Gen III CP-6302 Series
Category	Digital Camera
Language	English