This document does not contain any export-controlled information.
Configuration and Operation
20
Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021
Click SAVE.
Streaming Authentication Setting
From the drop-down list, select one of the following options:
·
Disable – Do not use streaming authentication (default setting).
·
Basic – A form of authentication that uses unencrypted base64 encoding. Basic Authentication
should generally only be used where transport layer security, such as HTTPS, is provided.
·
Digest – A form of authentication used over RTSP in which credentials are encrypted when
transmitted.
Click SAVE.
5.3.2.2 HTTPS
To use HTTPS on the camera, an HTTPS certificate must be installed. The HTTPS certificate can be
obtained either by creating and sending a certificate request to a Certificate Authority (CA) or by creating
a self-signed HTTPS certificate as described below.
Note:
The self-signed certificate does not provide the same level of security as a CA-issued certificate.
HTTPS allows secure connections between the camera and web browser using Secure Socket Layer
(SSL) or Transport Layer Security (TLS) to protect camera settings and username/password info. A self-
signed certificate or a CA-signed certificate is required to implement HTTPS.
To create a self-signed certificate
Before a CA-issued certificate is obtained, users can first create and install a self-signed certificate.
Under the Security category, click the HTTPS tab in the sidebar.
1. On the HTTPS page, click CREATE under Create Self-Signed Certificate. The Create Self-
Signed Certificate dialog box opens.
Create Self-Signed Certificate Request Dialog Box
2. Enter the information in the appropriate field. A definition of each of the required fields follows.
·
Country – Enter a two-letter combination code to indicate the specific country in which the
certificate will be used. For instance, type “US” to indicate United States.
·
State or province – Enter the local administrative region.
To Next Page
Loading...
Need help?
General
