FLIR Quasar Gen III CP-6302 Series - User Information and Factory Defaults; Full Factory Default Restore

This document does not contain any export-controlled information.
Configuration and Operation
55
Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021
User Information – Get User Privacy
In the screen above, both Admin and User are granted privileges of I/O access, Camera control, Talk and
Listen, which are the maximum privileges that can be granted.
Note:
User credentials and privileges are set in the User screen.
5.3.9.3 Factory Default
The Factory Default page is shown below. Follow the instructions to reset the camera to factory default
settings if needed.
Factory Default Screen
Full Restore
Click FULL RESTORE to restore the factory default settings. The system restarts in 30 seconds.