This document does not contain any export-controlled information.
Configuration and Operation
28
Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021
Traps are used by the camera to send messages to a management system for important events or status
changes.
·
Enable traps – Check this box to activate trap reporting.
·
Trap address – Enter the IP address of the management server.
·
Trap community – Enter the community to use when sending a trap message to the
management system. The default value is public.
·
Trap Option
·
Warm start – A warm start SNMP trap signifies that the SNMP device, such as the camera,
performs a software reload.
Click SAVE when finished.
5.3.3.4 UPnP
The System > Network > UPnP screen enables the Universal Plug-and-Play protocol on your network
devices.
UPnP Screen
UPnP Settings
·
Enable UPnP – If UPnP is enabled and a camera is discovered on the LAN, the icon of the
connected camera appears in My Network Places, allowing direct access, as seen below.
Direct Access to Camera with UPnP Enabled
Note:
To enable this function, make sure the UPnP component is installed on your computer. Refer to
Install UPnP Components for the Windows 7, 8, 8.1, and 10 procedure.
·
Enable UPnP port forwarding – When UPnP port forwarding is enabled, the camera is allowed to
open the web server port on the router automatically.
To Next Page
Loading...
Need help?
General
