This document does not contain any export-controlled information.
Configuration and Operation
27
Quasar CP-6302 Range User Guide - Ver. 8 - January 31, 2021
SNMP Settings Screen
SNMP v1/v2
·
Enable SNMP v1 or Enable SNMP v2 – Select the version of SNMP (v1 or v2) to use by checking
the relevant box.
·
Read Community – Specify the community name that has read-only access to all supported
SNMP objects. The default value is public.
·
Write Community – Specify the community name that has read/write access to all supported
SNMP objects (except read-only objects). The default value is private.
SNMP v3
SNMP v3 provides important security features including:
·
Confidentiality – Encryption of packets to prevent snooping by an unauthorized source.
·
Integrity – Message integrity to ensure that a packet has not been tampered with in transit
including an optional packet replay protection mechanism.
·
Authentication – To verify that the message is from a valid source.
To enable the SNMP v3 protocol, enter the appropriate data and passwords requested:
·
Enable SNMP v3 – Select the checkbox.
·
Security Name – See note below.
·
Authentication Type – Select MD5 or SHA from the drop-down list. The default setting is MD5.
See note below.
·
Authentication Password – See note below.
·
Encryption Type – Select DES or AES from the drop-down list. The default setting is DES. See
note below.
·
Encryption Password – See note below.
Note:
You may have to consult with your System Administrator to activate this function.
Traps for SNMP v1/v2/v3
To Next Page
Loading...
