5322A
Operators Manual
10
Optional Accessories
Table 3 lists optional accessories for the Product.
Table 3. Optional Accessories
Model Description
5322A/CASE Transit case for 5322A
Y5320 Rack mount kit for mounting a 5322A in a standard 19-inch rack.
5322A-LOAD 5 kV High Voltage Load adapter
Unpack and Inspect the Product
The Product ships in a container that prevents damage during shipping. Inspect
the Product carefully for damage, and immediately report any damage to the
shipper. Instructions for inspection and claims are included in the shipping
container.
To reship the Product, use the original packaging. If it is not available, you can
order new packaging from Fluke Calibration by identifying the Product model and
serial number.
When you unpack the Product, check for all the standard equipment listed in
Table 2. Report any shortage to the place of purchase or to the nearest
Technical Service Center. Visit the Fluke Calibration web site for Service Center
locations.
If performance tests are required for your acceptance procedures, refer to
Operator Maintenance for instructions.
Power the Product with 230 V or 115 V, 50 Hz or 60 Hz ac power (mains). It is a
laboratory instrument whose parameters are specified at operating temperatures
of 23 ±5 °C. Before powering on the Product, place it on a level surface.
WCaution
Do not cover the vents at the bottom side or the fan opening at
the rear panel.
Power Considerations
The Product is packed ready for use with the line voltage determined at the time
of ordering. If the selected line voltage does not match the power the Product will
be plugged into, then the Product line voltage setting must be changed and the
line fuse replaced.
To Next Page
Loading...
