Multifunction Electrical Tester Calibrator
Supported SCPI Commands
147
SYST:LOC
Description: This command returns the Product to the local mode. This
command is for USB interface.
STATus Subsystem
This subsystem is used to enable bits in the Operation and Questionable Event
registers. The Operation and Questionable: Event, Enable and Condition
registers can be interrogated to determine their state.
STATus
:OPERational
:EVENt?
:ENABle(?) <DNPD>
:CONDition?
:QUEStionable
:EVENt?
:ENABle(?) <DNPD>
:CONDition?
:PRESet
STAT:OPER:EVEN?
Description: Returns the content of Operational Data Event register. It is a
decimal value which corresponds to the binary-weighted sum of all
bits set in the register. Register is cleared after this query.
Query: STAT:OPER:EVEN?
STAT:OPER:ENAB? <DNPD>
Description: This command enables bits in the Operational Data Enable
register. Selected bits are summarized at bit 7 (OSS) of the
IEEE488.2 Status Byte register.
Parameters: <DNPD> Parameter represents desired value of
Operational Data Enable register as a
decimal number.
Example: STAT:OPER:ENAB 2 Set bit 1 in the Operational Data Enable
register (other bits are 0).
Query: SAF:OPER:ENAB? The Product returns the value of the register
as a decimal number. Example: 64 is
returned as 64.
To Next Page
Loading...
