Multifunction Electrical Tester Calibrator
Control the Product
25
Note
To exit the numeric entry without entering the typed value, push .
The Product changes the parameter to the value entered, displays
the entered value and the input box disappears.
3. To exit the edit mode, push the Exit softkey.
Cursor Key Editing
To enter a value with the cursor keys:
1. Push any one of the cursor keys to start an entry.
An arrowhead pointing up appears above a digit and an arrowhead pointing
down appears below the same digit to indicate which digit is being edited.
2. Push to increase or to decrease the active digit.
3. Push or to move to the next adjacent digit.
4. To return to the main screen, push the Exit softkey.
Edit Values with Rotary Knob Control
The rotary knob control works independently or in conjunction with the cursor
keys. To enter a value using the rotary knob:
1. Push in the rotary knob to enter the edit mode.
Because the rotary knob is used to position the cursor on a digit and
increment or decrement a digit, icons above and below the digit indicate
which of the two movements the rotary knob is set for: digit selection or digit
setting.
Digit selection is indicated by a left-pointing arrow above the digit and a right-
pointing arrow below the digit. Turning the rotary knob when these icons are
displayed moves the cursor to an adjacent digit.
Digit setting is indicated by an upward-pointing arrowhead above a digit and a
downward-pointing arrowhead below the same digit. Turning the rotary knob
when these icons are displayed increments or decrements the digit.
Note
To switch between digit selection and digit setting, push in the rotary
knob. Each push of the rotary knob toggles between the two
movements.
2. While in the digit setting mode, turn the rotary knob clockwise to increase the
selected digit or counterclockwise to decrease the selected digit. When the
digit reaches 9, further clockwise rotation sets the present digit to zero and
increments the digit to the left by one. When the digit reaches 1, further
counterclockwise rotation sets the selected digit to 9 and decrements the digit
to the left by one. If the selected digit is the most significant digit,
decrementing it from 1 to 0 will cause the digit to go blank.
3. To exit the edit mode, push the Exit softkey.
To Next Page
Loading...
