Contents (continued)
iv
Calibrate Loop Impedance Testers ....................................................... 184
Calibrate Leakage Current Testers ....................................................... 185
Passive, Differential, and Substitute Leakage Current Calibration .... 185
Calibrate Residual Current Device (RCD) in Installation Testers .......... 187
Calibrate RCD Trip Time ................................................................... 187
Calibrate Using 0.5 I Multiplier ....................................................... 187
Calibrate with 1 X I Multiplier ......................................................... 189
Calibrate with 1.4XI, 2 X I, and 5 X I Multipliers ............................ 190
Calibrate RCD Trip Current ............................................................... 191
Calibrate Residual Current Device (RCD) in PATs (Portable
Appliance Tester) .................................................................................. 192
Calibrate AC and DC Voltage (5322A/VLC only) .................................. 194
Calibrate Load Test for Appliance Testers ............................................ 197
Perform Flash Class I and Flash Class II Tests on (PAT)
Portable Appliance Testers ................................................................... 199
Calibrate Hipots ..................................................................................... 203
Measure High Voltage with the HV Input ........................................... 203
Measure High Voltage with the 10 kV Divider Probe ......................... 204
Measure High Voltage with the 80K-40 High Voltage Probe ............. 205
Measure Leakage Current with the 5322A-LOAD ............................. 206
To Next Page
Loading...
