OMNISCANNER User Guide
1 - 2
OMNIFIBER
TM
OMNIFIBER transforms OMNISCANNER and OMNISCANNER2 into a fiber optic
tool for testing and certification of multimode and single-mode fiber
premise networks. OMNIFIBER consists of two test heads that attach
directly onto OMNISCANNER and OMNIREMOTE to become a part of each
unit. Using the 1-Button Autotest feature, OMNIFIBER measures loss and
length over two fibers simultaneously. The measurements are com-
pared against the selected LAN standard for instant PASS/FAIL analysis.
OMNIFIBER measures loss at 850 and 1300 nm over multimode fiber and
at 1310 and 1550 nm over single-mode fiber.
Up to 1000 Autotests can be saved to nonvolatile memory. Saved results
can be easily uploaded to the PC with Scanlink
TM
software.
Scanlink
TM
Tools Software
PC-based software expands OMNISCANNER’s user interface and aids with
the management of projects. Scanlink Tools consist of the OMNISCANNER
Configuration software, the Scanlink Upload software, and the
OMNISCANNER Remote Control software. These programs allow you to
store, retrieve, manage, edit and print network cabling information.
Scanlink Tools provide the ability to create professional reports, remote
control OMNISCANNER, and define cable and project configurations that
can be downloaded to OMNISCANNER.
To Next Page
Loading...
