4 - 11
OMNISCANNER User Guide
Press (Set Default) to select it as the Configuration to be used
and to return to the SETUP screen.
While the selected Configuration is being loaded onto OMNISCANNER2, a
gauge indicates the progress. Do not remove the MultiMediaCard
from OMNISCANNER2 during the data transfer.
Autotest Run Options
Select Autotest Run Options to display the RUN OPTIONS screen.
With the presented options you are able to further customize the way
OMNISCANNER will perform an Autotest.
Press if you want OMNISCANNER to abort
the Autotest if a FAIL occurs. The Abort on Fail
box will be checked .
Use the ê to highlight the next checkbox.
Press if you want OMNISCANNER to auto-
matically move to the failed test result. The
Jump to Fail box will be checked .
Use the ê to advance to the Report: field and press ENTER. Select
Margin if you want OMNISCANNER to report the result, measured in dB,
for the worst margin. Select Worst dB if you want the worst overall dB
value to be reported, as in OMNISCANNER software versions prior to v4.0.
Press ENTER to set the default.
Note
Attenuation results in dB will always be reported for the worst value,
regardless of what is selected in the Report: listbox.
Use the ê to highlight the Fiber Test Options checkbox. You will be
able to define the way fiber optic Autotests are performed.
Press if you want OMNIFIBER to test the fiber link in both direc-
tions. The Test in Both Directions box will be checked .
Press (Save) to save your changes and return to the SETUP
screen.
To Next Page
Loading...
