OMNISCANNER User Guide
2 - 4
5. On finding OMNIREMOTE, the scanner reports: Acquiring Reference
Data. A gauge will indicate the progress.
6. Once the reference values has been recorded, OMNISCANNER displays
the REMOTE INFO screen.
7. Press ESC to return to OMNISCANNER’s SETUP screen.
Project Selection
A project name must be selected for test result management. Autotests
and Cables were previously assigned to a specific project through the
use of the OMNISCANNER Configuration utility. (See Chapter 9 -
Uploading and Printing for further informa-
tion about OMNISCANNER Configuration.)
The Project feature is very useful for grouping
test results and eases uploading and sorting
of Autotests stored in the scanner.
1. Use the é or ê to highlight Project: and
press ENTER.
2. Select the appropriate Project from the
pop-up list and press ENTER.
3. Use the é or ê to highlight Autotest:
and press ENTER.
4. Select the appropriate Autotest from the
pop-up list and press ENTER.
5. Use the é or ê to highlight Cable: and
press ENTER.
6. Select the cable type to be tested from the
pop-up list and press ENTER.
OMNISCANNER auto-senses the adapter and the
Adapter: field changes to reflect the adapter
that is currently attached. If the adapter is
changed, OMNISCANNER will automatically
adjust the content in the fields Autotest:
and Cable: to reflect the new setup.
Every Project has certain Autotests and cables
To Next Page
Loading...
