3 - 1
OMNISCANNER User Guide
Chapter 3 - Getting Started
Fiber Optic Networks
Charging OMNISCANNER’s Battery
In order to operate the OMNISCANNER and OMNIREMOTE with battery
power, the battery must first be charged. Until the charging cycle is
complete, the units can run with the AC adapter plugged in. (See
Appendix B - Batteries for more information about the batteries.)
OMNISCANNER’s Project Screen
The Project screen is designed to allow you to perform all typical work
flow operations. The Project, the test specifications, and the cable types
are all selectable from the Project screen.
Press the ON/OFF key to power the unit on and display the project
screen with its three user definable items:
Project, Autotest, and Cable.
The Project name will be highlighted. Use
the ê to move the highlight to the Autotest
currently selected. Use the ê to highlight
the currently selected Cable type.
OMNISCANNER will auto-sense the Adapter.
Battery and Memory status are graphically
indicated by gauges with a display ranging
from empty (left hand side) to full (right hand side).
Press (Setup) to select Autotests, configure Cables and Projects,
view OMNIFIBER information, edit User Options, and more.
Press (Measurements) to measure a cable’s performance, utiliz-
ing a variety of tests.
Press (Results) to view and manage stored test results.
To Next Page
Loading...
