OMNISCANNER User Guide
2 - 6
accuracy of the OMNISCANNER measurement system, a (marginal
FAIL) will be reported. If the measured result passes by an amount less
than or equal to the accuracy of the measurement, a (marginal
PASS) will be reported. Marginal results are very close to the PASS/FAIL
line and are within the accuracy of the measurement for that type of
link. Accuracy varies depending upon several conditions including the
type of link model and the measurement being performed. In most
cases this uncertainty zone is much less than 1 dB.
Saving Twisted Pair Autotest Results
1. Press (Save) from the AUTOTEST screen to open the SAVE
AUTOTEST screen, where the Autotests can be stored into
OMNISCANNER’s memory.
2. The Project: field contains the name of the project.
3. To assign a unique name to the Autotest, enter a Circuit ID into the
Circuit ID: field.
Circuit IDs can be setup to automatically
increment. (See Chapter 4 - Setup: Projects:
Editing a Circuit ID for further informa-
tion.)
If an incrementing Circuit ID was created in
the PROJECT Setup screen, the Circuit ID:
field will already contain the next available
Circuit ID that can be used as a default.
4. To change the name using OMNISCANNER’s edit feature, highlight the
field, and press ENTER to initiate the editing mode. (See Chapter 1 -
Introduction: Editing with OMNISCANNER for more information.)
5. To change the Name using the list function, press (List). The
CIRCUIT ID screen opens and displays all Circuit IDs available for the
project. Use the ç or è to quickly scroll through the pages. Use the é
or ê to highlight a Circuit ID and press ENTER to select it as the name
for the Autotest to be saved and return to the SAVE AUTOTEST
screen.
6. Press (Autotest Save Options) to open the SAVE OPTIONS
screen. Select the Destination for saved test results and select or
To Next Page
Loading...
