9 - 1
OMNISCANNER User Guide
Chapter 9 - Uploading and Printing
Scanlink
TM
Tools
Scanlink Tools consist of three parts: the Scanlink program, the
OMNISCANNER Configuration program, and the OMNISCANNER Remote
Control program.
Scanlink
TM
is designed to upload data measured with OMNISCANNER,
PENTASCANNER, SIMPLIFIBER, or CERTIFIBER. Collected data can be viewed or
saved to disk. Scanlink supports different report formats, like
Autotest Certification and Summary Reports that can be printed
from the PC to a printer or a file.
OMNISCANNER Configuration allows for easy setup and management
of projects, the configuration of OMNISCANNER, the specification of
tests, and the construction and structuring of cable libraries. Projects
can easily be downloaded to several OMNISCANNER. OMNISCANNER
Configuration allows you to import limits that can be used in custom
Autotests. These limits can be viewed and printed with the extensive
graphing utility.
OMNISCANNER Remote Control is designed to control OMNISCANNER
from your PC. It allows you to run Autotests that can be uploaded,
viewed, and printed. OMNISCANNER Remote Control contains an exten-
sive graphing utility allowing you to view and print saved graphs of
uploaded test results.
Refer to the Scanlink Tools on-line help for detailed instructions about
the installation and the use of the application. The Getting Started
Guide together with the software is part of the Scanlink Tools CD that
is included with OMNISCANNER. Scanlink Tools are also available for
download from the Fluke Networks web site at
www.flukenetworks.com.
To Next Page
Loading...
