OMNISCANNER User Guide
A - 2
· 850 nm Indicator (ORANGE) for switching fibers
· 1300 nm Indicator (ORANGE) for switching fibers
OMNIFIBER SM LED Displays
· 1310 nm Indicator (GREEN) for transmitting at 1310 nm
· 1550 nm Indicator (GREEN) for transmitting at 1550 nm
· 1310 nm Indicator (ORANGE) for switching fibers
· 1550 nm Indicator (ORANGE) for switching fibers
Power
· Removable, rechargeable battery pack
· 9.6 Volts @ 1900 mA-Hr NiMH (OMNISCANNER2)
· Built-in fast charger using AC adapter
· Charging Time: 3½ hours for fully discharged batteries.
· Battery life : 10+ hours operation (typical)
· AC: 15 VDC - 1 amp AC adapter for continuous operation or charging
Environmental
· Operating Temperature: 0°C to 50°C (32°F to 122°F)
· Storage Temperature: -10°C to 55°C (14°F to 131°F)
· Operating Humidity: (non-condensing): 5% to 90%
· Storage Humidity: 5% to 95%
· Regulatory Compliance: 2 Class A
Measurement Port (Test Interface)
· Ultra low Crosstalk test interface that supports testing of all four pairs
· 160 pin test interface connector which exceeds 10,000 mating cycles
· Variety of test cables and adapter modules support testing of 110
block and shielded modular jack and plug interfaces
Serial Port
· Connector: DB-9
· Baud Rate: 300 to 57,600 baud
· Parity: None
· Length: 8 Bits
· Handshaking: None, RTS/CTS, and XON/XOFF
Universal Serial Bus
· Type Self Powered Device
· Link 12 MB/s Full Speed Bulk Transfer with two 128 byte FIFOs and
Automatic Retry
· Connector Type ‘B’ Receptacle
To Next Page
Loading...
