OMNISCANNER User Guide
4 - 10
MT-F01-PP01-P01 (1st Circuit ID to be used)
MT-F01-PP01-P02 (2nd Circuit ID to be used)
MT-F01-PP01-P03 (3rd Circuit ID to be used)
.
.
.
MT-F01-PP01-P48 (48th Circuit ID to be used)
MT-F01-PP02-P01 (49th Circuit ID to be used)
..
..
..
MT-F01-PP02-P48 (96th Circuit ID to be used)
MT-F02-PP01-P01 (97th Circuit ID to be used)
MT-F02-PP01-P02 (98th Circuit ID to be used)
...
...
...
MT-F12-PP02-P48 (last Circuit ID to be used)
Press (Save) to save the Circuit ID and return to the PROJECTS
screen.
Note
To quickly edit the Last Circuit ID, press (Copy) once you
have completed the First Circuit ID. This function will copy the First
Circuit ID into the Last Circuit ID field. Now edit the Last Circuit ID
field.
Press ESC to return to the SETUP screen.
Configurations
Select Configurations to display the CONFIGURATIONS screen. It
contains a list of all configurations which are currently stored on the
MultiMediaCard that can be read by OMNISCANNER2. (See Chapter 11 -
MultiMediaCard for more information about the MMC).
The predefined Default Configuration is
always present and can be used to reset
OMNISCANNER to the factory default. It contains
the following projects: TIA, ISO/IEC, VENDOR,
OMNI, IEEE, ATM, AS/NZ, ANSI.
Use the é or ê arrow key to highlight a specific
Configuration.
To Next Page
Loading...
