1 - 9
OMNISCANNER User Guide
Displaying OMNISCANNER and OMNIREMOTE Results
OMNISCANNER and OMNIREMOTE are used together to perform measure-
ments, which allow the scanner to verify installed links or assist in the
diagnosis of physical layer network problems. To accomplish these
measurements, OMNISCANNER and OMNIREMOTE are connected at either
end of a network-cabling link. The end at which the scanner is con-
nected, is referred to as the ‘Scanner end’, and the end at which the
remote unit is connected, is referred to as the ‘Remote end’.
OMNISCANNER displays test results for both ends of the link. Press
or to toggle the display between Scanner and Remote test
results.
Note
Refer to the graphics in Chapter 2 - Getting Started: Typical Test
Configurations for instructions on connecting OMNISCANNER and
OMNIREMOTE for basic link and full channel tests.
Indicates
OMNI-
SCANNER
test
results.
Indicates
OMNI-
REMOTE
test
results.
Toggles the display
from Scanner to Remote end
test results.
To Next Page
Loading...
