OMNISCANNER User Guide
2 - 14
5. Press the
AUT OTES T
key to start the test.
6. Press ESC at any time to cancel the Autotest.
7. The COAX TESTS screen is displayed when the Autotest is com-
pleted.
Saving Coaxial Autotest Results
1. Press (Save) from the AUTOTEST
screen to open the SAVE AUTOTEST screen,
where the Autotests can be stored into
OMNISCANNER’s memory.
2. The Project: field contains the name of the
project.
3. To change the name using OMNISCANNER’s
edit feature, highlight the field, and press
ENTER to initiate the editing mode. (See
Chapter 1 - Introduction: Editing with
OMNISCANNER for more information.)
4. To assign a unique circuit id to the Autotest,
enter a Circuit ID into the Circuit ID: field.
Circuit IDs can be setup to automatically
increment. (See Chapter 4 - Setup: Projects:
Editing a Circuit ID for further information.)
If an incrementing Circuit ID was created in the PROJECT Setup screen,
the Circuit ID: field will already contain the next available Circuit ID
that can be used as a default.
5. To change the circuit ID using the list function, press (List).
The CIRCUIT ID screen opens and displays all Circuit IDs available for
the project. Use the ç or è to quickly scroll through the pages. Use
the é or ê to highlight a Circuit ID and press ENTER to select it as the
name for the Autotest to be saved and return to the SAVE AUTOTEST
screen.
6. Press (Autotest Save Options) to open the SAVE OPTIONS
To Next Page
Loading...
