Fluke OMNIScanner 2 - Multimediacard Interface; Memory

A - 3
OMNISCANNER User Guide
· Recommended Cable Full Speed Shielded Twisted Pair with A-B
Plugs (USB V1.1 Complaint)
MultiMediaCard Interface
· Link 4.6 MB/s SPI Mode with 16 bit CRC
· Format 512 byte sector size, 32Bit FAT File System
· Socket Non-Locking Seven Contact with Ejector
· Recommended Media Sandisk SDMB-xx or Infineon
MultiMediaCard-F00xx (xx denotes memory size in Megabytes)
Memory
· Control: Flash Memory allows electronic upgrading of both
OMNISCANNER and OMNIREMOTE programs.
· Test Storage: Up to 1000 complete Autotest results can be stored in
permanent flash memory. They are not subject to loss due to power
or battery failures.
OMNISCANNER Autotest Functions
· Full suite of tests to determine if cable meets generic cabling or
network type requirements.
• Extended performance range Cabling (CAT 6 and CAT 7)
• TIA standard Autotests
• ISO/IEC standard Autotests
• Vendor specific Autotests
• IEEE standard Autotests
• ATM standard Autotests
• FDDI standard Autotests
• AS/NZ standard Autotests
• ANSI standard Autotests
OMNISCANNER Test Functions
· Wire Map
· NEXT (Near End Crosstalk)
· Return Loss
· Attenuation
· ELFEXT (Equal Level FEXT)
· ACR (Attenuation to Crosstalk Ratio)
· Bandwidth
· Length/Delay
· Resistance
· Power Sum NEXT, ACR and ELFEXT
· Coax Tests: Length, Delay, Impedance, Resistance