PostBase Fusion
162
… with automatic feeding / sealing (PostBase Fusion Feeder)
Envelopes are not sealed. Sealing is disabled.
Set the switch to the “seal” position (see chapter 6.3.3.2).
Sealant tank is empty or too low.
Fill more SEALIT sealing fluid (see chapter 15.9.1).
Envelopes are not properly
sealed.
Stroke your hand firmly over the envelope’s / letter
stack’s flap area.
Moistening sponge and brush are dried because
the sealant tank was empty over a longer period of
time.
Remove basket with sponge and let sponge soak
up completely (see chapter 15.9.3).
Sponge is dirty or worn.
Clean or replace the sponge (see chapter 15.9.3).
Brush is dirty or worn.
Clean or replace the brush (see chapter 15.9.4).
You have used unsuited envelopes.
Only use envelopes that are suited for sealing by
machine. Observe specifications (see page 187).
Adjust the moistening level (see chapter 15.9.2).
Use SEALIT, sealing fluid available from FP or
authorized FP dealer.
Function / button
‘Seal Only’ is missing.
Sealing function is switched off.
Exit the “Special Functions” menu.
Set the switch to the “seal” position (see chapter 6.3.3.2).
Open the “Special Functions” menu again.
Issue Possible cause and remedy
To Next Page
Loading...
