OmniSTAR 8200HP User Manual
Issue 1.07, 10/2008
iii
One-Year Limited Hardware Warranty
OmniSTAR B.V and its operating companies world-wide (OmniSTAR),
warrants this product to be free from defects in workmanship and material for a
period of one year from the date of original sale by OmniSTAR or its
authorised dealers, to the original purchaser or end user.
OmniSTAR reserves the right to repair and/or replace, at its option, any part or
parts found to be defective, provided such defects, in their opinion, are due to
faulty material or workmanship and are not caused by unauthorised or
improper repair or abuse, or normal wear. Purchaser shall be responsible for
shipping and insurance of the returned product for repair under this warranty.
OmniSTAR will pay shipping and insurance for the product's return to
purchaser provided that the product returned proves to be defective under this
limited warranty.
This warranty applies only to normal usage of the product. It does not apply to
units or electronic circuit boards defective due to improper installation or
handling. Physical damage due to lightning or other electrical discharge and
units subjected to fresh or salt-water contamination are not covered.
OmniSTAR reserves the right not to warrant the product if, upon request,
sufficient proof of recommended installation compliance as laid out in this
manual is not provided. No other warranties are expressed or implied. No other
warranties exist.
OmniSTAR assumes no responsibility for any consequential or incidental
losses or damages of any nature with respect to the use of this product.
REVISION HISTORY
Issue 1.0 August 2006 First release
Issue 1.02 August 2006 Small textual changes, firmware
upgrade procedure added.
Issue 1.03 September 2006 Sales e-mail OSSA changed
GPS status indication in GGA/RMC
NMEA messages clarified.
Issue 1.04 December 2006 CAN / NMEA2000 messages clarified
Description of lock display screen
revised.
Issue 1.05 April 2007 NMEA digits changed to 8
Issue 1.06 May 2007 DB9 pin layout added
Issue 1.07 October 2008 Modifications to pin layout
Manual Reference: OmniSTAR 8200HP User Manual
Copyright OmniSTAR B.V. 2007. No part of this manual can be reproduced
without the express permission of OmniSTAR B.V.
To Next Page
Loading...
