Fuji Electric FRENIC MEGA G2 Series - Page 203

5.2 Function Code Tables
5-19
FUNCTION CODES
Chap 5
Function
code
Name
Control method and Data setting range
Change when running
Data copying
Factory
default
Related page
P60
(For Synchronous motor)
(Armature resistance)
0.000 to 50.000 Ω (phase)
N
Y1Y2
*7
5-208
P61
(d-axis inductance)
0.00 to 500.00 mH (phase)
N
Y1Y2
*7
P62
(q-axis inductance)
0.00 to 500.00 mH (phase)
N
Y1Y2
*7
P63
(Induced voltage)
80 to 240 V (200V class); 160 to 500 V (400V class)
N
Y1Y2
*7
P64
(Iron loss)
0.0 to 20.0% (100% = Iron loss for motor rated current, base speed)
Y
Y1Y2
*7
P65
(q-axis inductance magnetic
saturation correction)
0.0 to 100.0% (100% = No magnetic saturation) ; 999 (factory adjustment
value)
Y
Y1Y2
999
5-208
P74
(Current command value
when starting)
10 to 200% (100%= motor rated current)
Y*
Y1Y2
80 *7
5-208
P83
(For adjustment by
manufacturer) *9
0.0 to 50.0; 999
Y
Y1Y2
999
5-209
P84
(For adjustment by
manufacturer) *9
0.0 to 100.0; 999
N
Y1Y2
999
P85
(Flux limitation value)
50.0 to 150.0; 999
Y
Y1Y2
999
5-208
P86
(For adjustment by
manufacturer) *9
0.0 to 100.0
N
N
0.0
5-209
P87
(NS discrimination current
command value)
0 to 200% (100% = Motor rated current)
N
Y1Y2
60
5-209
P88
(For adjustment by
manufacturer) *9
0 to 100; 999
N
Y1Y2
999
5-209
P89
(Control switching level)
0; 1 to 100
N
Y1Y2
0
P90
(Overcurrent protection
level)
0.00 (cancel); 0.01 to 4000 A
N
Y1Y2
*7
5-209
P95
(Magnetic pole position
sensor offset)
0.0 to 359.9 degree; 999 (offset not set)
Y
Y
999
5-209
P99
Motor 1 selection
0: Motor characteristics 0 (Fuji standard IM, 8-series)
1: Motor characteristics 1 (HP rating IMs)
2: Motor characteristics 2 (Fuji dedicated motors for vector control)
3: Motor characteristics 0 (Refer to replacement material when using Fuji
standard IM, 6-series)
4: Other IMs
5: Motor characteristics 5 (Fuji premium efficiency motors)
20: Other (synchronous motors)
21: Motor characteristics (Fuji synchronous motor (GNB2 series))
22: Motor characteristics (Fuji synchronous motor (GNF2 series))
23: Motor characteristics (Fuji synchronous motor (GNP1 series))
N
Y1Y2
5
5-210
*6: Factory defaults are depended on motor capacity.
*7: The constant for Fuji standard synchronous motor GNB series is set as the factory default.
*9: This is a function code for adjustment by the manufacturer. Do not access these function codes.