z
When the punching feature of a finisher is defective, output is delivered to the center tray instead of the
finisher tray. Remove the output delivered to the center tray every now and then.
îš„ Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
z
If the [Original Orientation] setting differs from the actual document orientation, the machine may not
detect the top of the document correctly.
îš‹ Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
îš‹ Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder. Always select [Sideways Images] when the top of the
document is placed facing the left side (horizontal text).
îš„ Output/Offset
Available when the output destination tray is selectable.
Allows you to select the output destination tray. To select the output destination tray and
offset operation, select [More].
îš„ Offset
Available when the output destination tray is not selectable.
[Offset] screen appears.
z
For more information, refer to "Copy Output (Specifying Finishing Options)" (P.174).
[Output Destination/Offset Stacking] screen
Allows you to select the output destination and offset options.
îš„ Offset Stacking
[Offset Stacking] screen will appear.
To Next Page
Loading...
Need help?
General
