Copy
192
Copy
3
1 Select [Area 1], [Area 2], or [Area 3].
2 Select the text box for [X1], and enter the value for X1 using the numeric keypad.
3 Select the text box for [Y1], and enter the value for Y1 using the numeric keypad.
4 Select the text box for [X2], and enter the value for X2 using the numeric keypad
5 Select the text box for [Y2], and enter the value for Y2 using the numeric keypad.
z
If all of [X1], [Y1], [X2], and [Y2] are set to [0], the area will be invalid. If no other area is specified, the Delete
Outside/Delete Inside feature cannot be used.
z
Pressing the <C (Clear)> button clears the value you have entered.
Clear Area 1 (Area 2 or Area 3)
Clears all the values set for Area 1 (Area 2 or Area 3).
Stored Programming (Calling a Stored Program for Build Job)
This feature allows you to call a stored program for Build Job.
z
This feature is the same as "Stored Programming" > "Calling a Stored Program" > "Calling a Stored Program for Build Job". For
more information, refer to Calling a Stored Program for Build Job(P.467).
To Next Page
Loading...
