Fax
270
Fax
4
2 Select any option.
îš„ Priority Send
îš‹ Off
Priority Send is not applied.
îš‹ On
Priority Send is applied.
z
If the Priority Send feature is selected during transmission, the fax will be sent after the current transmission
ends.
z
In redial mode, the fax will be resent preferentially after the specified redial interval.
z
The Priority Send feature cannot be set separately for each recipient of Broadcast and multi-polling jobs.
z
You can give priority to a pending job. For more information, refer to "Job Status" (P.485).
îš„ Delay Start
îš‹ Off
Delay Start is not applied.
îš‹ Specific Time
Delay Start is applied.
z
You can specify a time within 24 hours in 1 minute increments. You cannot specify a date.
z
You can set [Delay Start] independently for each address number. For information on how to register address
numbers, refer to "Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
z
If you use address numbers or group dial numbers to specify recipients for the Broadcast Send feature, the
[Delay Start] setting specified for each address number is invalid.
z
If the fax cannot be sent at the specified time because, for example, the telephone line is busy, it will be sent
as soon as the line becomes available.
îš„ Specific Time
Displays the [Delay Start - Specific Time] screen.
z
Refer to "[Delay Start - Specific Time] Screen" (P.270).
[Delay Start - Specific Time] Screen
This screen allows you to specify the start time for fax transmission.
z
You can change the default value of [Delay Start - Specific Time]in the System Administration mode. For more information, refer to
"Tools" > "Fax Service Settings" > "Fax Defaults" > "Delay Start - Specific Time" in the Administrator Guide.
To Next Page
Loading...
Need help?
General
