Stored Programming
460
Stored Programming
8
îš„ Store
Register a stored program.
z
Refer to "Registering Stored Programs" (P.460).
îš„ Store Build Job
Register a stored program for Build Job.
z
Refer to"Registering Stored Programs for Build Job" (P.462) .
îš„ Delete
Deletes a stored program. Select the stored program number to be deleted.
z
Refer to"Deleting Stored Programs" (P.463) .
îš„ Enter/Change Name
Enter or change the name of a stored program.
z
Refer to "Entering/Changing a Stored Program Name" (P.464).
îš„ Assign/Change Icon
Specify an icon for a registered stored program.
z
Refer to "Assigning/Changing Icons for Stored Programs" (P.465).
Registering Stored Programs
Up to 100 actions can be registered with one stored program. Up to 40 stored programs
can be registered in the machine.
Actions registered in stored programs No.1 and 2, or No.1 to 9 can also be performed by
using one touch buttons <53> and <54>, or <46> to <54>. (This feature is available only
when the optional Fax service is installed.)
The following describes how to register actions with stored programs.
z
If registered settings such as tray paper size and comments, or default values in the System Settings are
changed after a stored program is registered, the program's content also changes.
z
Services using System Settings, Job Flow Sheet, Network Scanning, or Address Book cannot be registered.
z
The registering procedure for a stored program is canceled when the <Interrupt> button is pressed, the Auto
Clear feature causes a time-out, or a pop-up window (paper jam, etc.) appears.
z
There are two ways in which address numbers and stored programs are assigned to the one touch buttons.
Select either of the following. By default, [Type 1] is selected. For information on how to change the settings
registered to the one touch buttons, refer to " Tools" > "Common Service Settings" > "Screen/Button Settings"
in the Administrator Guide.
z
[Type 1]
The buttons 1 to 52 are used for address numbers and they correspond to the registered address numbers
0001 to 0052, while the buttons53 and 54 are used for stored programs and they correspond to the
registered stored programs 1 and 2.
z
[Type 2]
The buttons 1 to 45 are used for address numbers and they correspond to the registered address numbers
To Next Page
Loading...
Need help?
General
