Stored Programming
466
Stored Programming
8
Calling a Stored Program
The following describes how to call a stored program.
When you call a specified stored program, the last screen shown when you registered the
stored program appears.
1 Press the <Services Home> button.
2 Select [Stored Programming].
3 Select a number of a stored program containing the features you want to use.
z
You can only select registered numbers.
z
Select [ ] to return to the previous screen or [ ] to move to the next screen.
z
Scroll the list by drag or flick operation to switch the screen to be displayed. For information on how to drag or
flick, refer to "Touch Screen" (P.84).
z
After the stored program has been called, the machine sounds an audible tone. If a failure occurs, the
machine sounds a fault tone.
z
For information on how to change the volume of the sound that notifies that a stored program has been called, refer to "Tools" >
"Common Service Settings" > "Audio Tones" > "Stored Programming Complete Tone" in the Administrator Guide.
To Next Page
Loading...
Need help?
General
