Tools
214
Tools
5
îš„ SMTP Server Port Number
Enter a port number in the range from 1 to 65535.
The default value is 25.
z
Do not use the numbers assigned to the other ports.
îš„ E-mail Send Authentication
Select one from [Off], [POP before SMTP], or [SMTP AUTH].
z
If [POP before SMTP] is selected, the POP3 settings must be set.
z
AUTH GSSAPI (only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH-LOGIN, or AUTH
CRAM-MD5 can be used as an authentication method.
îš„ Login Credentials for E-mail Send
Select the login user name when sending e-mails from [Remotely Authenticated User] and
[System].
When [Remotely Authenticated User] is selected and if the machine tries authenticating
the remote server before a job startup, the machine performs verification at the time of
transmission with the remotely authenticated user name and password. You can also select
the post-failure behavior of the machine from [Cancel E-mail Send] and [Relogin using
System Data]. If you do not set remote authentication, the machine uses the user ID and
passcode of the machine for authentication.
îš„ SMTP AUTH Login Name
Enter the user name for verification purposes at the SMTP server with up to 64 characters.
îš„ SMTP AUTH Password
Enter the password for verification purposes at the SMTP server. Up to 64 single-byte
characters are allowed.
z
If you do not set the password, leave the text boxes blank and select [Save].
Remote Authentication/Directory Service
You can make the settings for the remote authentication server and directory service.
Authentication System Setup
îš„ Authentication System
Allows you to select the authentication system from [Kerberos (Windows2000)], [Kerberos
(Solaris)], [LDAP], [SMB].
After you change the authentication system, folders and job flow sheets used with the
previous authentication system are not deleted automatically. If these folders or job flow
sheets are no longer needed, delete them from the machine. If the same user IDs are also
used on the new authentication system, folders and job flow sheets can be used by the
same users.
îš„ Server Response Time-Out
Set the server time-out response between 1 and 75 seconds in 1 second increments.
To Next Page
Loading...
Need help?
General
