Configuration for Authentication
439
Authentication and Accounting Features
14
Configuration for Authentication
This section describes the settings to use the Authentication feature on the machine.
"Installation Overview" (P.439)
"Enabling Authentication" (P.439)
"Changing the Default Authorization Group Settings" (P.442)
"Creating an Authorization Group" (P.443)
Installation Overview
To use the Authentication feature, configure the following settings.
z
If job flow sheets, which are no longer available for use because of a change in the Login Type, are linked to
folders, they cannot be edited or copied, but still can be used. If you cancel the links, however, the job flow
sheets will no longer be displayed and will be unavailable.
Change the default authorization group settings and add an authorization group, as
necessary.
Login to Local Accounts
Specify the Login Type and access control, and then create a user.
Enabling Authentication
This section describes the procedures for [Login to Local Accounts] and [Login to Remote
Accounts] respectively.
When [Login to Local Accounts] is Selected
Perform the following procedures to use the local authentication.
1
Press the <Log In/Out> button.
2
Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s passcode,
and select [Enter].
z
The default user ID is "11111".
z
The default passcode is "x-admin".
3
Select [Tools] on the Services Home screen.
4
Select [Authentication/Security Settings].
5
Select [Authentication].
6
Select [Login Type].
To Next Page
Loading...
Need help?
General
