Printer Environment Settings
338
Printer Environment Settings
7
Installation When Using USB Port
This section describes how to install the machine using a USB interface.
The following shows the reference section for each procedure.
"Step 1 Preparations" (P.338)
"Step 2 Configuration on the Machine" (P.338)
"Step 3 Configuration on the Computer" (P.339)
"CentreWare Internet Services Setting Items" (P.339)
Step 1 Preparations
The following items are required to connect the machine to a computer via a USBinterface.
z
USB cable
z
Media (Software/Product Manual) provided with the machine
Step 2 Configuration on the Machine
The following describes the configuration procedures to use a USB interface on the
machine.
z
To print binary data using a USB interface, set [Adobe Communication Protocol] to [RAW]. For more
information, refer to "USB" (P.195).
z
You can configure the settings using CentreWare Internet Services. For items that can be configured using
CentreWare Internet Services, refer to "CentreWare Internet Services Setting Items" (P.339).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s passcode,
and select [Enter].
z
The default user ID is "11111".
z
The default passcode is "x-admin".
3) Select [Tools] on the Services Home screen.
2
Enable the USB port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [USB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
To Next Page
Loading...
Need help?
General
