Fuji Xerox DocuCentre-V C2265 Administrator's Guide

Setup
297
Tools
5
F Code
Select whether or not to use F code communications.
F Code is the transmission procedure set by the Communications and Information Network
Association of Japan and is the T.30 (communication protocol) method for using
subaddresses that are standardized by the ITU-T.
For F code (sub address) and password, you can use up to 20 digits 0 to 9, *, and #.
1 Select [On].
2 Enter the F code with the numeric keypad.
Note
z
The F code consists of “0” + folder number. For example, if the folder number is 123, the F code will be “0123”.
3 Enter the password as required with the numeric keypad, and then select [Save].
Note
z
You can enter up to 20 digits for the password.
Relay Broadcast
Set the instruction given to a relay station, which is used when the machine is a base
station and the registered speed dial is a relay station for relay broadcast.When selecting
[On], set [Relay Station ID], [Print at Relay Station], and [BroadcastRecipients].
1 Select [On].
2 Enter a 2-digit relay station ID with the numeric keypad.
Note
z
The relay station ID is the address number for the base station (the machine) already registered on the relay
station.
3 Select [Speed Dial 001<->099].

Fuji Xerox DocuCentre-V C2265 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Resolution	1200 x 2400 dpi
Scan Resolution	600 x 600 dpi
Monthly Duty Cycle	Up to 50, 000 pages
Duplex Printing	Yes
Memory	2 GB
Hard Disk Drive	160 GB
Print Technology	Laser
Copy Resolution	600 x 600 dpi
Scan Type	Color Scanner
Fax Transmission Speed	33.6 kbps
Max Paper Size	A3
Network Connectivity	Ethernet
Scan Speed	55 ppm (color) / 55 ppm (mono)
Connectivity	USB 2.0
Paper Size	A4, A5
Operating System Compatibility	Windows, Mac
Print Speed	Up to 25 ppm (color) / 25 ppm (mono)