Fuji Xerox DocuCentre-V C2265 Administrator's Guide

Maintenance
88
Maintenance
3
appears on the touch screen.
Replacing Staple Cartridge (for Finisher-A1)
When the optional Finisher-A1 is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important
z
The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance. Use only
staple cartridges recommended by Fuji Xerox.
z
When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you replace the staple cartridge.
z
When replacing the staple cartridge, press the <Machine Status> button and check the current status for the
staple cartridge even when the control panel is lit.
Note
z
To order a staple cartridge, contact our Customer Support Center.
1 Make sure that the machine is not operating, and open the finisher front door.
2 Take the staple cartridge out of the finisher.
3 After you take out the staple cartridge, check inside of the finisher for any remaining
staples.

Fuji Xerox DocuCentre-V C2265 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Resolution	1200 x 2400 dpi
Scan Resolution	600 x 600 dpi
Monthly Duty Cycle	Up to 50, 000 pages
Duplex Printing	Yes
Memory	2 GB
Hard Disk Drive	160 GB
Print Technology	Laser
Copy Resolution	600 x 600 dpi
Scan Type	Color Scanner
Fax Transmission Speed	33.6 kbps
Max Paper Size	A3
Network Connectivity	Ethernet
Scan Speed	55 ppm (color) / 55 ppm (mono)
Connectivity	USB 2.0
Paper Size	A4, A5
Operating System Compatibility	Windows, Mac
Print Speed	Up to 25 ppm (color) / 25 ppm (mono)