Tools
240
Tools
5
Login Credential to Access Destination
Set whether or not to use a user authenticated by the remote server when the user logs in to
the destination computer for the Scan to PC service. This setting is effective for remote
authentication.
îš„ None
Does not use the remotely authenticated user.
îš„ Remotely Authenticated User
Uses the user name and the password of the remotely authenticated user for login.
User Name for FTP Scan
When the remotely authenticated user name is used as a login user name for FTP transfers
for the Scan to PC service, specify whether or not to include the domain part of the
credentials.
îš„ User Name Only
Uses only the user name part (before "@") of the login credential for the login name. The
domain part is not used.
îš„ Add Domain Name
Uses the full login credential name, including the domain name (after "@"), for the user
name.
Original Size Defaults
Set the document size displayed in [Original Size] in the [Layout Adjustment] screen. You
can assign a document size to each of the 17 buttons other than [Auto Detect].
If you frequently use non-standard size paper for scanning, assigning the paper sizes to the
buttons will save your time to specify the size each time.
îš„ A/B Series Size
You can select a size from A and B series sizes such as A4 and B5.
îš„ Inch Size
You can select a size from Inch series sizes such as 8.5 x 11" and 11 x 17".
îš„ Others
You can select a size from other sizes than the above series such as photo and postcard
sizes.
îš„ Custom Size
You can enter any size. Set the width (X) from 15 to 432 mm, and the height (Y) from 15 to
297 mm in 1 mm increments.
Output Size Defaults
Set the sizes to display in [Output Size] when selecting [Enter Output Size] for scanning
documents at [Reduce/Enlarge] in the [Layout Adjustment] screen.
You can assign any output size to output size buttons.
Assigning the output sizes to the buttons will save your time to specify the size each time.
To Next Page
Loading...
Need help?
General
