Fuji Xerox DocuCentre-V C2265 Administrator's Guide

Interface Cables
21
Before Using the Machine
1
Interface Cables
When you connect the machine directly to your computer, use the USB interface.
When you connect the machine to a network, use the Ethernet interface.
Using the USB Interface
The USB interface of the machine supports USB 2.0.
This section describes the installation procedures for the USB interface.
1 Press the power switch to switch off the power.
2 Make sure that the touch screen is blank and the <Power Saver> button is not lit.
3 Open the front cover.
4 Press the main power switch to the [ ] position to switch off the main power.
5 Remove the rear right cover.
6 Connect a USB cable to the USB 2.0 interface connector.
7 Return the rear right cover to its original position.
8 Connect the other end of the USB cable to the computer.
9 Press the main power switch to the [ ｜ ] position to switch on the main power.
10 Close the front cover.
11 Press the power switch to switch on the power.
12 Restart the computer.
Reference
z
For more information on setting items, refer to "Printer Environment Settings" (P.335).
Using the Ethernet Interface
The Ethernet interface of the machine supports the following three types.
z
1000BASE-T

Fuji Xerox DocuCentre-V C2265 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Resolution	1200 x 2400 dpi
Scan Resolution	600 x 600 dpi
Monthly Duty Cycle	Up to 50, 000 pages
Duplex Printing	Yes
Memory	2 GB
Hard Disk Drive	160 GB
Print Technology	Laser
Copy Resolution	600 x 600 dpi
Scan Type	Color Scanner
Fax Transmission Speed	33.6 kbps
Max Paper Size	A3
Network Connectivity	Ethernet
Scan Speed	55 ppm (color) / 55 ppm (mono)
Connectivity	USB 2.0
Paper Size	A4, A5
Operating System Compatibility	Windows, Mac
Print Speed	Up to 25 ppm (color) / 25 ppm (mono)