Fuji Xerox DocuCentre-V C2265 Administrator's Guide

PCL Emulation
683
Appendix
16
Forcible Output in Emulation Mode
In emulation mode, data is not output until one complete page of data is prepared or the
page break command is received. For a USB interface, if printing ends in the middle of a
page, the next data set waits until the time set with [Auto Eject Time] elapses.
Reference
z
For more information on forcible printing, refer to "Job Status" in the User Guide.
z
For more information on the auto eject time, refer to Auto Eject Time(P.195).
PCL Emulation Settings
The following table shows the emulation parameters and their values for PCL emulation.
PCL Settings List
The following table describes the parameters that can be set with the mode menu.
Parameter Item No. Value
Paper tray 201 Sets the paper tray to be used for printing.
[0] (Default): Auto
[1]: Tray 1
[2]: Tray 2
[3]: Tray 3
[4]: Tray 4
[5]: Tray 5
Note
z
When any of Trays 1 to 4 is selected, the paper size is determined by the size of paper
loaded in the tray, and thus [Paper Size] cannot be set.
Note
z
When [Auto] is selected and paper of the same size in the same orientation in multiple
trays is loaded, paper will be fed in the order of Tray 1 J Tray 2 JTray 3 J Tray 4. If
paper of the same size is loaded in multiple trays but in different orientations, feeding
of the paper loaded in the landscape orientation is prioritized.
Auto size 202 Sets the default paper size. Only available when [Paper Tray] is set to [Auto].
Only cut sheet can be set.
[3]: A3
[4] (Default): A4
[5]: A5
[14]: B4
[15]: B5
[21]: 8.5 X 14"
[22]: 8.5 X 13"
[23] (Default): 8.5 X 11"
[24]: 11 X 17"
[25]: Custom Size
[30]: 8K
Important
z
When any of Trays 1 to 4 is selected, [Paper Size] cannot be set. The paper size loaded
in the specified tray is displayed.
Note
z
When any of Trays 1 to 4 is selected, the paper size is determined by the size of paper
loaded in the tray, and thus [Paper Size] cannot be set.
Note
z
Depending on the combination of [Original Size] and [Paper Size], [?] may be displayed
for the magnification. In this case, the document is printed at a scale of 100%.

Fuji Xerox DocuCentre-V C2265 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Resolution	1200 x 2400 dpi
Scan Resolution	600 x 600 dpi
Monthly Duty Cycle	Up to 50, 000 pages
Duplex Printing	Yes
Memory	2 GB
Hard Disk Drive	160 GB
Print Technology	Laser
Copy Resolution	600 x 600 dpi
Scan Type	Color Scanner
Fax Transmission Speed	33.6 kbps
Max Paper Size	A3
Network Connectivity	Ethernet
Scan Speed	55 ppm (color) / 55 ppm (mono)
Connectivity	USB 2.0
Paper Size	A4, A5
Operating System Compatibility	Windows, Mac
Print Speed	Up to 25 ppm (color) / 25 ppm (mono)