Authentication and Accounting Features
440
Authentication and Accounting Features
14
7
Select [Login to Local Accounts], and then select [Save].
z
For more information on the authentication method, refer to "Login Type" (P.315).
8
Select [Access Control].
9
Select [Service Access].
10
Select [Unlocked] for the required services to permit users unlimited access, and then select
[Save].
11
After you finish settings for each feature, select [Close].
12
To disable button operations on the control panel, select [Device Access] and select
[Locked], and then select [Save] and then [Close].
13
Select [Passcode Entry for Control Panel Login] under [Passcode Policy]. Select [On] to
prompt users to enter their passcode, or select [Off] if the passcode entry is not required,
and then select [Save] and then [Close].
14
Select [Create/View User Accounts].
15
Select a
user displayed as [
<Availabl
e>], and the
n select [C
reate/Delete].
16
Enter a User ID and select [Save].
17
Select [Account Limit].
18
Configure the [Account Limit] and [Feature Access] settings for each service, and then
select [Close].
19
If necessary, select a user role and an authorization group for the user under [User Role]
and [Add This User To Authorization Group] respectively, and then select [Save].
20
Select [Close] repeatedly until the [Tools] screen is displayed.
21
Select [Close].
z
Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
z
The machine enters the Login mode, and [Login] is displayed at the lower left of the Services Home screen.
z
When [Locked (Show Icon)] is selected for a service under [Service Access],[ ]is displayed on the button of
the applicable service on the Services Home screen. Also,
[ : Requires Login]is displayed at the lower left of the Services Home screen.
[ ]and[ : Requires Login]are not displayed after authentication.
z
When [Locked (Hide Icon)] is selected for a service under [Service Access] the applicable service is not
displayed on the Services Home screen. The services is displayed after authentication.
When [Login to Remote Accounts] is Selected
Perform the following procedures to use remote authentication.
To Next Page
Loading...
Need help?
General
