1. Connect the MNT LAN ports of both DX100 controller modules to the server:
Figure 68: LAN connection between server and DX100 controller enclosure
a. CM#0 MNT port has to be connected to the left onboard LAN port (LAN1 at LoM).
b. CM#1 MNT port has to be connected to the uppermost LAN port of the PCI card in
slot 7.
Appropriate labels should be already affixed to the cables or can be taken
from the section LAN Cabling (SCALE) of the label sheet, see "CS800
Labelsheet" on page 93.
2. Connect the host interface adapters CA#1 of both DX100 controller modules to the
server:
ETERNUS CS800 101
5 Installing the ETERNUS CS800 S6 Modules
To Next Page
Loading...
