5.3 Cabling the ETERNUS CS800 S6 System
Figure 74: Scale System with the 10 Gb/s Ethernet and 8Gb/s FC*) options
*)The 8Gb/s FC ports are operable only if the appropriate option was purchased too
Proceed as follows to connect the Scale system to the mains as well as to the LAN and
optionally to the SAN or appropriate devices:
1. Connect a power cable to each power supply of the components.
2. Connect the LAN ports and optionally the iRMC port to the appropriate networks. At
least one of the LAN ports must be connected.
3. If your ETERNUS CS800 also provides FC support: Connect the FC ports to the SAN or
directly to the appropriate devices.
106 ETERNUS CS800
To Next Page
Loading...
